NEW: Smart network..
About us
Our Products
PROFI CLASS E.LITE CLASS NET CLASS CATV Products   Digital modulators
  Analog modulators
  Analog Headends
Fiber optic products Special offer Discontinued Sheet Metal Processing
Our partner's offer
HDCVI Recorders Satellite dishes Terr. Amplifiers LNBs Coaxial cable Wall sockets Connectors
Design Assistant
Join us
Pricelist request

Product List

CATV Products - 5 to 16 LNBs DiSEqC switches

DiSEqC switches designed for the most demanding users. Up to 16 satellite input ports, terrestrial input is provided for connecting of terrestrial antenna. Support of DiSEqC 1.1 or 1.2 is required on the receiver's side.

Advantages of PROFI CLASS switches
  • weatherproof outdoor plastic housing
  • support for Twin/Quad/Octo LNB ("High ISO")
  • configurable operation mode DiSEqC 1.1 / 1.2
  • terrestrial input
  • short-circuit protection
  • extended temperature range
How to set-up system with 8/1 or 16/1 switch?
  1. Make sure that your receiver supports DiSEqC 1.1 or DiSEqC 1.2.
  2. If DiSEqC 1.1 is available, check allowed range of parameter "uncommitted"
  3. If "uncommitted" can be set to full number of inputs (8 or 16), set configuration switch DIP1 to ON and DIP2 to OFF; in receiver's menu assign "uncommitted" parameter for each LNB to number of used input
  4. If "uncommitted" parameter is limited to number 4, set configuration switch DIP1 to OFF and DIP2 to ON; in receiver's menu assign "uncommitted" and "committed" parameter according to the table
  5. If DiSEqC 1.1 is unavailable, set configuration switch DIP1 to ON and DIP2 to ON, than enter procedure for setting up DiSEqC motor, following user's manual to your receiver
Useful information
  • We recommend to operate the switches in DiSEqC 1.1 mode whenever possible, because of straightforward setup procedure
  • If DiSEqC 1.2 setup routine (motor emulation) is to be performed, check first transponders on which receiver tests particular satellites: avoid using similar frequencies for different satellites, as this may confuse setup procedure. If necessary, change test frequencies.
  • The switches are able to operate in DiSEqC 1.0 mode, however due to DiSEqC protocol restriction only inputs 1 to 4 are available. For this kind of operation, set both configuration levers DIP1 and DIP2 to OFF
  • Always reset the product by short disconnecting from power after DIP-levers configuration was altered
Quick contacts

Sales department:
Tel.: +420 376 323 813

Technical support:

Need more options?
Proceed to Contact page

General trade conditions (PDF) EN
Find the right product
Method 1:
Enter product's part number
(at least 3 characters are required):
Method 2:
Choose desired product category:
Method 3:
Try out our app Design Assistant

Switch to mobile version

© Copyright EMP-Centauri s.r.o. All rights reserved.    Webmaster:   Background image: pixabay